It is difficult to avoid some problems after the long-term use of the fusion splicer. In some cases, it may be that the machine has some fatal faults, such as damage to the internal parts. Then you need to return to the factory for repair, but In most cases, some simple faults may occur, and the user can solve the problem himself, but it is also important that the user of the fusion splicer can maintain the machine and judge and solve simple problems.
1. As part of the hardware, the V-shaped groove belongs to the gun. If it is not straight, the bullet that is shot out will be thrown away, and the fiber will be out of alignment. The fiber presser is also the crosshair, so when there is a problem, it will not The fiber can be fixed.
2. In addition, as part of the software, observing an optical path of the fiber is like our eyes. If it is not clear, the core cannot be completed. However, the firmware inside the machine is similar to our mind, and we must always keep it in the latest. status.
3. There is also a part of the consumables, the welding machine can only use the electrode rod, this is like a bullet, if there is a bad bomb situation, its serious results can be known.
Automatic hemming fusion machine
2016-12-23
Mobile web site